Sometimes this crosshair can be obscured by the Windows taskbar remaining in the ‘up’ position. Solution: The first crosshair is located in the lower-left corner of the screen. (applicable only in Pre-X* version calibration) or, only see two crosshairs, located at the middle of the screen and the upper-right corner. Contact tech support for more troubleshooting. Internal hardware problem in either touchscreen or controller. Make sure both white dots are on the same side.Ĥ. ( Applicable to laptop add-ons and built-in touch screen kits only) Black slide connector and the cable are connected backwards. In X version, touching anywhere other than the circles.ģ. In Pre-X version calibration, touching other than the three crosshair locations, such as the ‘set default’ or ‘cancel’ buttons. Touching a location other than the targets. Finger bounced or rolled when touching a location, causing a double-trigger.Ģ. Solution: This problem can occur for four reasons:ġ.
Problem: ‘Cross-distance too close’ or ‘Invalid calibration points, default value used’ error message when calibrating. Solution: Remove driver disk from floppy disk drive and hit any key to continue start-up Problem: ‘NTLDR.exe is missing’ error message at computer start-up. If you have older version, please download This controller has red light and DB9 cable.
Elo touchscreen calibration invoke by side buttons serial#
If you have a Serial ProE-X or ProE controller: The current Mac driver is 1.64, contact us if you have the older version. If you have older version, please download. The current drivers for Windows & Linux are on one CD, rev. This controller has red light & USB cable. USB-XD, USB-SB, USB-X or USB controllers:
0 kommentar(er)
